|
|
MODEL RP-700 RECEIVER PROTECTOR
The RP-700 Receiver Protector offers receiver protection necessary to allow operation in close proximity to high-power transmitters. The solid state circuitry furnishes protection to all RF signals, even those in the microwave band.
With the RP-700 the receiver is protected at all times, even when in the off position or tuned to other frequencies. The protector is inserted in the transmission line between the antenna and the receiver and limits the signal level applied to the receiver while providing very low insertion loss under lower signal conditions.
SPECIFICATIONS (50 OHM LOAD)
 | Insertion Loss: Less than 0.5 dB from DC to30 MHz. |
| Maximum Input Level: 3.5 Amperes rms (10 Amperes peak-to-peak). 175 Volts rms (500 Volts peak-to -peak) behind 50 Ohms. |
| Inter-modulation Distortion: For two 0.3 Volt (+3 dBm) tones, third order products are down no less than 60 dB (Will not degrade a receiver whose intercept point is +25 dBm or less). |
| Temperature Operating: -30° C to +65° C (with external heat sink). Storage: -55° c to +75° c. |
| Power Requirements: None (completely passive). |
| Installation: Inserted in transmission line between antenna and receiver. |
| Connectors: Input and Output: SO-239 |
| Size: 3.375" L x 2.0" W x 1.5" H (8.5 cmx 5 cm x 3.8 cm) |
| Weight: 4 ounces (125 grams). |
